b'Mould Release and FinishingMOULD PLUG AFTER RELEASETooling System RangesSmall Mould Low Volume System *GC 200 Iso Tooling Gelcoat* RM 1000/50 was developed for low volume moulds.R 568 LGT Iso Clear Skin Coat A lower cost system 2.5 : 1 Resin to Glass RatioRM 1000/50 Tooling ResinHigh Stiffness System **GC 206/207 Vinyl Ester Tooling GelcoatR 842 Low shrink Vinyl Ester Clear Skin Coat ** RM 2000/50 was the 1st MEKP cure system and is stillextensively used in Marine Industry. RM 680 TPA Vinyl Ester Clear Skin Coat 4:1 resin to Glass Ratio RM 2000/50 Tooling ResinHigh Glass Content System ***GC 206/207 Vinyl Ester Tooling GelcoatR 842 Low shrink Vinyl Ester Clear Skin Coat *** RM 2550 was developed to improve mechanical performanceand a higher glass content gives a durable lighter weight mould. RM 680 TPA Vinyl Ester Clear Skin Coat 2.5:1 Resin to Glass Ratio RM 2550 Tooling ResinVinyl Ester System ****GC 206/207 Vinyl Ester Tooling GelcoatR 842 Low shrink Vinyl Ester Clear Skin Coat **** The full Vinyl Ester system is ideal for heat resistance moulds for post curing up to 120 degC. Used extensively for infusion and marine RM 680 TPA Vinyl Ester Clear Skin Coat high durability moulds. RM 3000 can replace the need for a separate skin coat to reduce cost and waste. RM 3000 Vinyl Ester Tooling ResinGet in touch: KoverTek Limited Follow us on Facebook, Twitter, LinkedIn Units 1-4 Poldermere and InstagramRed House LaneTel: 01604 781702 HanningtonEmail: Info@kovertek.com NorthamptonshireWeb: kovertek.com NN6 9SZ'