b'KoverTek Tooling RangePRODUCT DESCRIPTION APPLICATIONNorester 879 Plug Laminating Resin Suitable for Polystyrene PlugsNCL 809 DO65 Sprayable CNC Putty Apply to min thickness of 8mm(2 layers) for machiningNCL 815 Extrudable CNC Putty Apply to Final thickness of 12mm for machining (3 layers)Nord 230BV Primer Plug Primer (Sprayable) Apply 450-600 MicronsNord GC 210 Sprayable Plug Lacquer Apply several thin layers to the primed plugRoar Extreme 900/ Extreme 910 Polishing Compounds For compounding from 800 grit sandingTek-Kote Mould Cleaner Mould Cleaner Solvent Wipe on Wipe OffTek-Kote Mould Sealer Semi Permanent Mould Sealer Wipe on Leave On or Wipe on SpreadTek-Kote Fast Release Semi Permanent Release Agent Wipe on Leave OnNorester GC 200 Gelcoat Iso Tooling Gelcoat (Brush Apply) For low volume cycle mouldsNorester GC 201 Gelcoat Iso Tooling Gelcoat (Spray Apply) For low volume cycle mouldsNorester GC 206 Gelcoat Vinyl Ester Tooling Gelcoat (Brush Apply) For high cycle moulds & high temp resistNorester GC 207 GelcoatVinyl Ester Tooling Gelcoat (Spray Apply) For high cycle moulds & high temp resistNorester 842 Vinyl Ester Resin Vinyl Ester Skin Coat (Clear) For low shrink and high surface finishNorester 680 Vinyl Ester Resin Vinyl Ester Skin Coat (Clear) For low shrink and high surface finishPRODUCT DESCRIPTION APPLICATIONNorester RMTooling Resin based on polyester resin,A low cost system. 2.5 : 1 Resin to Glass.1000/50 especially formulated for mould making.Ideal for low volume cycle moulds.NORESTER 1000/50 is filled and pre-accelerated.Norester RMTooling Resin formulated from an unsaturatedExtensively used in the Marine industry. 4 : 1 Resin to glass.2000/50 polyester resin. It is filled, promoted andApply min thickness of 8mm (2 layers) for machining.pre-accelerated. Formulated for mould making. Norester RMTooling Resin based on polyester resin forA rapid tooling resin with good surface appearance. Good curing.2550 the production of composite moulds with lowGood mouldability, and fast wet out, resin to glass ratio 2.5 : 1 Creates shrinkage. It is a product ready to use, filled andLighter moulds with better mechanicals properties hence lower tooling pre accelerated resin costs. Superior mechanical properties due to a glass content approximately 28% higher than with conventional tooling resins.Norester RMVinyl Ester Tooling Resin especially formulatedDesigned to polymerize at room temperature following addition of 3000 for producing composite moulds for applicationsnormal MEKP catalysts.Resin pre-accelerated and promoted, permits where high thermal and chemical resistance area fast curing and a rapid manufacture of moulds.An easy to use required product with low shrinkage hence high surface finish of the finished mould/parts.Fast build up of Barcol hardness. Improvement of the mould rigidity and low cost of mould production. Low exotherm curing system.Low viscosity.'